User's Manual

64 Preparing the Script Files for Deployment Using Microsoft Windows PE
Perform the following steps to edit the default partition configuration default
values, as necessary:
1
Edit the default utility partitioning variable ( DT_PARTN_UP=ON ),
if necessary. This variable sets whether you want to install the Dell utility
partition.
NOTE: Dell recommends that you install the Dell utility partition.
2 Edit the default variable value for the default hard drive ( DT_HD=0 ),
if applicable.
NOTE: Ensure that the default variable value for DT_HD is set to a valid
non-removable disk, and not to removable media such as virtual media.
3 Edit the default variable value (in MB) for the primary operating system
partition (
DT_OS_SIZE=4000 ), if applicable.
4 Edit the default variable value for file system type ( DT_OS_FSTYPE=
FAT32
), if applicable.
NOTE: The valid values are FAT32 and NTFS.
5 If the DT_PART_UP variable is set to ON , edit the default variable value
(in MB) for the utility partition (
DT_UP_SIZE=32 ), if applicable.
6 If the DT_PART_UP variable is set to ON , edit the default variable value
for the utility partition installation package location
(
DT_UP_IMAGE=%DT_SYSTEMS%\UPIMG.BIN ), if applicable.
You should have already copied the
UPIMG.BIN file to the directory, as
instructed in "Preparing the Directory Structure for Deployment in
Microsoft Windows PE" on page 31. Edit this variable only if you have
changed the name or path of the utility partition installation package.