User's Manual

62 Preparing the Script Files for Deployment Using Microsoft Windows PE
Specifying the RAC Configuration Variables
The IP address for your target system RAC is set in the sample script to
10.98.8.121 by default. Edit this value to reflect the actual IP address of
your target system RAC, if applicable. Additionally, the RAC configuration
file used to configure your RAC is set by default to raccfg.ini. If you use the
RACCAP.BAT sample script to generate the raccfg.ini file, there is no need to
edit this default setting. If you have made any modifications to the sample
scripts or to the suggested directory structure, you must confirm that
raccfg.ini is correctly named and that the path is correctly set for your
deployment. To edit the RAC capture variables, locate the following lines in
RACCAP.BAT:
set DT_RAC_CAPFILE=
%DT_SYSTEMS%\%DT_PLATFORM%\raccfg.ini
To edit the RAC replication variables, locate the following lines in
RACREP.BAT:
:: RAC section
set DT_NICCFG=10.98.8.121
set DT_RAC_CAPFILE=
%DT_SYSTEMS%\%DT_PLATFORM%\raccfg.ini
Specifying Variables Used to Create Disk Partitions and Install the
Dell Utility Partition
NOTE: If the primary deployment state (DT_PARTN) is set to OFF in
PARTCFG.BAT, the partitioning deployment state subsection is skipped.
The PARTCFG.BAT sample script provides the following disk partitioning
default values. These values must be confirmed in some cases, and modified
in other cases, before performing a deployment. Locate the partn label to find
the following lines in PARTCFG.BAT: