Quick Reference Guide

10 Introduction
RAID Replication
The RAID replication feature reads the RAID configuration information from
the source system and creates a raid.ini file. This raid.ini file can be applied
to the RAID configurations of the target system. The RAID replication
requires both, the source system and the target system to have similar
RAID controllers.
RACADM Replication
The RACREP.BAT sample script applies RAC configuration options to the
target system based on the configuration information that has been saved in a
configuration file. User input is optional, depending on variables set in the
RACREP.BAT sample script. This script uses the RACADM.EXE utility to
configure the RAC in the target system using the RAC configuration file,
raccfg.ini. The raccfg.ini configuration file is passed as the first parameter to
the RACREP.BAT script. If this parameter is not passed, the default variable
values used in this script are set in the TKENVSET.BAT scripts. An optional
second parameter can be passed to this file, which specifies the IP address
used in configuring the RAC. The raccfg.ini file is generated with the
RACCAP.BAT sample script.
Other Documents You May Need
In addition to this guide, you can access the following guides available at
support.dell.com/manuals. On the Manuals page, click Software Systems
Management. Click on the appropriate product link on the right-side to
access the documents.
•The Dell OpenManage Deployment Toolkit Quick Installation Guide
provides information about installing and deploying DTK on supported
Dell systems. The guide is available as part of the DTK download and at
support.dell.com .
•The
Dell OpenManage Deployment Toolkit User's Guide provides best
practice procedures that focus on the basic tasks for successful deployment
of Dell systems.
•The
Dell Systems Software Support Matrix provides information about the
various Dell systems, the operating systems supported by these systems,
and the Dell OpenManage components that can be installed on
these systems.