User's Manual

62 Preparing the Script Files for Deployment Using Microsoft Windows PE
5 If the DT_PART_UP variable is set to ON , edit the default variable value
(in MB) for the utility partition (
DT_UP_SIZE=32 ), if applicable.
6 If the DT_PART_UP variable is set to ON , edit the default variable value
for the utility partition installation package location
(
DT_UP_IMAGE=%DT_SYSTEMS%\UPIMG.BIN ), if applicable.
You should have already copied the
UPIMG.BIN file to the proper
directory, as instructed in ""Preparing the Directory Structure for
Deployment in Microsoft Windows PE" on page 31." Edit this variable
only if you have changed the name or path of the utility partition
installation package.
Editing DTK Task Scripts
The task scripts called by the master batch file do not require any edits
(with the following exceptions) if the default variable values are utilized in
the TKENVSET.BAT scripts. However, if you make any changes to the
default values set by the TKENVSET.BAT, you must make the same edits to
the matching default values set in the appropriate task scripts. Locate the
USER MODIFICATION REQUIRED heading in the task scripts to find the
variable values you might need to edit. Each of the following task scripts can
be called by the user-written master batch script during a full deployment:
•RACREP.BAT
•RAIDCFG.BAT
•SYSREP.BAT
•PARTCFG.BAT
RACREP.BAT
The RACREP.BAT sample script applies RAC configuration options to the
target system based on configuration information that has been saved in a
configuration file. User input is optional, depending on variables set in the
RACREP.BAT sample script. This script uses the RACADM.EXE utility to
configure the RAC in the target system using the RAC configuration file,
raccfg.ini, passed as the first parameter to this script. If this parameter is not
passed, the default variables values used in this script are set in the
TKENVSET.BAT scripts. An optional second parameter can be passed to
this file, which specifies the IP address to be used to configure the RAC.