Quick Reference Guide

292 Summary of SYSCFG and RAIDCFG Options
FILE LOCATION: C:\Work\DTK\DTK_CLI_3.4\Source\DTKCLaE.fm
DELL CONFIDENTIAL – PRELIMINARY 12/3/10 - FOR PROOF ONLY
-fd
or
failoverd
rive
ch:targ, ch:targ, ...
or ch:targ:lun,...
or ch:targ:enc
channel:target, or
channel:target:lu
n, or
channel:target:en
closure
Specifies the location of the failover
drive in an array.
For SCSI controllers, the value of
LUN should always be 0.
For SAS controllers, the value of
enclosure can be non-zero, in which
case you must specify values for
channel, target, and enclosure.
NOTE: From DTK 2.4 onwards, the -fd
option creates dedicated hot spares
instead of global hot spares. To set
global hot spares, see Table 4-10.
Optional.
See Table 4-4 for
specific usage
information.
-i <filename> Reads the RAID configuration
information from the given .ini
filename and creates the RAID
configurations on the specified
controllers.
Mandatory.
See Table 4-14
for specific usage
information.
-l
or
logfile
<filename> Logs command line output to a file. Optional.
See Table 4-15
for specific usage
information.
-o <filename> Reads the RAID configurations from
all available controllers and write
these configurations in the given .ini
filename.
Mandatory.
See Table 4-14
for specific usage
information.
-r
or
raid
<valid RAID level
number>
Sets the RAID level for the array.
Valid RAID values are 0, 1, 5, 10, 50.
If no value is specified for RAID, 0 is
taken as the default level.
Optional.
See Table 4-4 for
specific usage
information.
Table D-2. RAIDCFG Short and Long Format Options
(continued)
Option Valid Arguments Short Description Mandatory or
Optional