Owner's Manual

file:///T|/htdocs/SOFTWARE/dtk/3_4/readme/WINDOWS_README.TXT[10/22/2012 4:32:30 PM]
* DTK does not support Non RAID (Volume) mode on s100/s300
controller.
* S300 controller Cachepolicy setting is "Not Applicable". Hence
VD created with different cachepolicy settings from OROM utility
will be displayed as "Not Applicable".
SYSCFG Issues:
* In DRAC 5, the --virtualmedia and --vflash options do not work if there
is an active virtual media session. Disconnect the virtual
media using the DRAC GUI. Log into DRAC.
Click Media > Virtual Media > Disconnect.
* The syscfg --bootseq command detects CD-ROM with SAS/SATA controllers
as unk.emb.1.
* On R815, syscfg power --profile option allows to set to apc, though
apc is not supported on R815. syscfg does not throw an error message.
* The Demand-based Power Management (DBPM) option does not work on
PowerEdge 1855 systems with BIOS versions earlier than A05.
* On Windows PE 3.0, when you run the syscfg command to list all
available options, if you press CTR + C before the command fully
executes, an error message is displayed. Click OK.
You can ignore the message.
* The Demand-based Power Management (DBPM) option does not work on
PowerEdge 1855 systems with BIOS versions earlier than A05.
* The option for "powerctl," which is "softshutdown," does not
work in Windows PE.
* The "--solbitrate" option in "solcfgparams" and the
"--mgscommbitrate" option in "serialcfgparams" accept a baud rate
of 57600, but tools such as "ipmish" and "solproxy" do not
function at that baud rate for PowerEdge systems.
RACADM Issues:
* If you use virtual media to boot into Windows PE, executing
certain RACADM commands may cause Windows PE to crash.
* After generating the rac configuration file using the
"racadm getconfig -f <file_name>" command, comment out the following
properties in the configuration file before you update a
configuration using the "racadm config -f <file_name>" command:
#cfgRacTuneCtrlEConfigDisable=0
#cfgRacTuneLocalConfigDisable=0