Owner's Manual

file:///T|/htdocs/SOFTWARE/dtk/3_3/readme/WINDOWS_README.TXT[10/22/2012 4:46:55 PM]
be automatically Set to "Off" during the next reboot.
RACADM Issues:
* If you use virtual media to boot into Windows PE, executing
certain RACADM commands may cause Windows PE to crash.
* After generating the rac configuration file using the
"racadm getconfig -f <file_name>" command, comment out the following
properties in the configuration file before you update a
configuration using the "racadm config -f <file_name>" command:
#cfgRacTuneCtrlEConfigDisable=0
#cfgRacTuneLocalConfigDisable=0
* VLAN objects (cfgNicVLanEnable, cfgNicVLanId, and cfgNicVLanPriority)
displayed using the local RACADM command
"racadm getconfig -g cfgLanNetworking"
or VLAN objects generated in the configuration file using the
local RACADM command
"racadm getconfig -f <file name>" do not contain the leading "#" symbol
which indicates that they are read-only.
Windows PE Installation Issues:
* If virtual flash is enabled and does not contain a valid image
(for example, if the virtual flash contains a corrupt or
random image), you may not be able to install Windows 2000 or
Windows 2003, locally or remotely. To fix this issue, install
a valid image on virtual flash or disable virtual flash if it
will not be used during the installation procedure.
* Running partcfg.bat may fail when virtual media is enabled.
For the hard disk, partcfg.bat uses the driver letter "c:".
When virtual media is enabled, sometimes, the virtual device
gets assigned with the drive letter "c:" And, partcfg.bat
execution fails. To run partcfg.bat successfully, either disable
the virtual media or use the diskpart command to assign a free
driver letter for partcfg.bat.
Windows PE Issues:
* Windows PE 2.0 and 3.0 for 64-bit do not support
racadm.exe for DRAC 4.
* Windows 2008 64-bit cannot be installed using DTK with
Windows PE 3.0. Use Windows PE 2.0 for installing
Windows 2008 64-bit.
* When using the H200 driver provided in Windows PE 3.0 (x64),
the diskpart command does not list the first virtual disk
created. Download the latest driver from the support site
at support.dell.com.