Owner's Manual

file:///T|/htdocs/SOFTWARE/dtk/3_3/readme/WINDOWS_README.TXT[10/22/2012 4:46:55 PM]
for assigning more than 10 Global Hot spares.
* SW RAID controllers S100 and S300 will not be detected in the Microsoft
Windows Server 2003 with SP1 (32-bit).
* DTK does not support Non RAID (Volume) mode on s100/s300
controller.
* S300 controller Cachepolicy setting is "Not Applicable". Hence
VD created with different cachepolicy settings from OROM utility
will be displayed as "Not Applicable".
SYSCFG Issues:
* In DRAC 5, the --virtualmedia and --vflash options do not work if there
is an active virtual media session. Disconnect the virtual
media using the DRAC GUI. Log into DRAC.
Click Media > Virtual Media > Disconnect.
* The syscfg --bootseq command detects CD-ROM with SAS/SATA controllers
as unk.emb.1.
* On R815, syscfg power --profile option allows to set to apc, though
apc is not supported on R815. syscfg does not throw an error message.
* The Demand-based Power Management (DBPM) option does not work on
PowerEdge 1855 systems with BIOS versions earlier than A05.
* On Windows PE 3.0, when you run the syscfg command to list all
available options, if you press CTR + C before the command fully
executes, an error message is displayed. Click OK.
You can ignore the message.
* The Demand-based Power Management (DBPM) option does not work on
PowerEdge 1855 systems with BIOS versions earlier than A05.
* The option for "powerctl," which is "softshutdown," does not
work in Windows PE.
* The "--solbitrate" option in "solcfgparams" and the
"--mgscommbitrate" option in "serialcfgparams" accept a baud rate
of 57600, but tools such as "ipmish" and "solproxy" do not
function at that baud rate for PowerEdge systems.
* On PowerEdge 1950, 2950 and PowerVault NX 1950 systems with
internal USB, BIOS setting configuration for internal USB Port is
possible only if User Accessible/external (UA) USB ports are set to
"All Ports On." If UA USB ports are not set to "All Ports On"
and you try to configure the BIOS setting for the internal USB port
using SYSCFG, the configuration will appear to be successful
but the changes will not take effect after the next reboot. If
UA USB ports settings are changed from "All Ports On" to
"All Ports Off" or "Only Back Ports On," the USB port will