User's Manual

Preparing the Script Files for Deployment Using Embedded Linux 117
racrep.sh
The racrep.sh sample script applies RAC configuration options to the target
system based on configuration information that has been saved in a
configuration file. User input is optional, depending on variables set in the
racrep.sh sample script. This script uses the racadm wrapper script or the syscfg
utility (depending on the version of RAC on your system) to configure the RAC
in the target system using the RAC configuration file, raccfg.ini, passed as the
first parameter to this script. If this parameter is not passed, the default
variables values used in this script are set in the tkenvset.sh scripts. An
optional second parameter can be passed to this file, which specifies the IP
address to be used to configure the RAC. The raccfg.ini file is generated with
the raccap.sh sample script. See "raccap.sh" for information about using the
raccap.sh sample script to capture RAC configuration information.
NOTE: For x9xx systems, racrep.sh and sysrep.sh have duplicate functions. If you
run racrep.sh followed by sysrep.sh, the latter overwrites the former’s settings.
raidcfg.sh
The raidcfg.sh sample script configures RAID controllers detected on the
system. User input is optional to run this script. The parameter is a name or
path to a log file. This parameter is not set to any value by default, and no log
file is generated. The default variable values used in this script are set in the
tkenvset.sh scripts. This script uses the raidcfg.sh utility to automatically
configure the detected controllers on your target system. For example, for the
first controller discovered, if raidcfg.sh discovers only one attached hard drive,
the script tries to create RAID 0; if two hard drives are discovered, a RAID 1
configuration is enabled; if three or more hard drives are discovered, a RAID 5
configuration is enabled.
NOTE: On the detected controller, a RAID virtual disk is created only if the array
disks connected to that particular controller have space available and, where
applicable, are not part of an already existing array group.
sysrep.sh
The sysrep.sh sample script applies SYSCFG options to the target system
based on configuration information that has been saved in a configuration
file. User input is optional to run this script, depending on the variable
settings in the sysrep.sh scripts. This script uses the syscfg utility to configure
the BIOS and BMC in the target system using the configuration file,