Quick Reference Guide

Messages and Codes 319
UPINIT Common Error Codes and Messages
The UPINIT utility checks your commands for correct syntax. When you
enter a command, a message is displayed stating the results of the command.
Failure Messages
The UPINIT utility failure messages provide error codes to help diagnose why
some commands do not succeed.
142 Cannot stat /etc/omreg.cfg file. Please ensure
/etc/omreg.cfg file is present and is valid for
your environment. You can copy this file from the
DTK iso.
143 Getting nicselection settings failed.
144 HAPI Driver Load Error.
145 Filter action power reduction is only supported
for the system power warn/fail filters.
146 TPM Clear settings requires setup password.
147 There is currently no TPM Clear request pending.
148 Password is not required for retrieving the TPM
options.
149 Setup password is required for setting the TPM
options.
150 Invalid Password override.
151 Invalid TPM set option.
152 There was an error setting the TPM option.
153 There is no setup password installed on this
system.
154 The setup password supplied is incorrect. Please
try again.
Table B-1. SYSCFG Error Codes and Messages (continued)
Error
Code
Message