Quick Reference Guide

50 SYSCFG
lancfgparams
or
lcp
Configures and displays LAN configuration
parameters. This option can be replicated.
--ipaddrsrc static, dhcp Sets the IP address source for the LAN channel.
This suboption can be replicated.
--ipaddress <ipaddress> Sets the IP address for the LAN channel.
This suboption cannot be replicated.
--subnetmask <subnetmask> Sets the subnet mask for the LAN channel.
This suboption can be replicated.
--gateway <gateway> Sets the gateway for the LAN channel. This
suboption can be replicated.
--commstring <string> Sets the community string (maximum of
16 printable ASCII characters) used in a platform
event trap (PET). This suboption can be
replicated.
--destipaddr <ipaddress> Sets the destination IP address for the alert
destination specified with the alertdest suboption.
The destipaddr suboption is dependent on the
alertdest suboption. If the alertdest suboption is
not specified on the command line, the first alert
destination (
alertdest=1) is set with this
IP address. This suboption can be replicated.
--alertdest 1, 2, 3, 4 Sets the destination for the LAN alert.
This suboption can be replicated.
--vlantag enable, disable Enables or disables VLAN tagging. This suboption
can be replicated.
--vlanid 0–4095 Sets the 12-bit VLAN ID. This suboption can
be replicated.
--vlanpriority 0–7 Sets the VLAN priority value. This suboption can
be replicated.
--macaddress NA Displays the BMC MAC address. This suboption
cannot be replicated.
--nicselection shared,
sharedfailover,
dedicated
Sets the operating mode of the NIC to
shared/sharedfailover/dedicated. Some of these
options are not applicable on certain systems.
fullduplex enable, disable Enables or disables full duplex on the RAC network
interface.
Table 3-3. BMC and Remote Access Controller Configuration Options (continued)
Options Suboptions Valid
Arguments
Description