Quick Reference Guide

RACADM 115
Error Messages
When using RACADM utility commands and subcommands, you may encounter one or more of the
following errors:
• Local error messages occur when problems occur with syntax, typographical errors, incorrect names,
and so on.
Example:
racadm < subcmd > : ERROR : < message >
• Transport error messages occur when the RACADM utility communication paths to the RAC are
not accessible.
Example:
racadm < subcmd > : Transport : ERROR : < message >
• RAC firmware errors occur when a fault exists in the RAC firmware operation.
Example:
racadm < subcmd > : Firmware : ERROR : < message >
NA racdump Displays status and general RAC information. See "racdump" for more
information about the subcommand options and arguments.
NA racreset Resets the RAC. See "racreset" for more information about the subcommand
options and arguments.
NA racresetcfg Resets all database configuration parameters to default values; equivalent to a
soft reset. See "racresetcfg" for more information about the subcommand
options and arguments.
NA setrac Sets RAC parameters from the managed system. See "setrac" for more
information about the subcommand options and arguments.
Table 6-1. RACADM Options (continued)
RACADM
Options and
Arguments
RACADM
Subcommands
Short Description