Setup Guide

1
Introduction
This guide provides information about the software requirement, system requirements and the steps to
install, configure, and uninstall the Dell OpenManage Connection version 3.0 for IBM Tivoli Network
Manager (ITNM) IP Edition.
Dell OpenManage Connection for IBM Tivoli Network Manager (ITNM) IP Edition provides end-to-end
monitoring capability for Dell Original Equipment Manufacturing (OEM) Servers, Dell Datacenter Scalable
Solutions (DSS), Dell PowerEdge servers, chassis, workstations, storage arrays and network switches. You
can monitor the Dell infrastructure from the ITNM IP Edition console, which is a single point of
management for the complete hardware environment in your data center. It also supports console
launch of Dell devices and other Dell tools to perform troubleshooting, configuration, and management
activities.
The following Dell devices are supported by the Dell OpenManage Connection:
• Dell OEM servers
• Dell Datacenter Scalable Solutions (DSS)
• Dell 10th generation of PowerEdge servers to Dell 13th Generation of PowerEdge servers
• Dell Precision rack workstations
• Dell Remote Access Controllers:
– Integrated Dell Remote Access Controller 8 (iDRAC8)
– Integrated Dell Remote Access Controller 7 (iDRAC7)
– Integrated Dell Remote Access Controller 6 (iDRAC6)
– Dell Remote Access Controller 5 (DRAC5)
• Dell Chassis:
– Dell PowerEdge FX2
– Dell PowerEdge VRTX
– Dell PowerEdge M1000e
• Dell Storage Arrays:
– Dell Compellent Storage Arrays
– Dell PowerVault NX 10th Generation (10G) to 12th Generation (12G) Storage Arrays
– Dell EqualLogic PS-Series Storage Arrays
– Dell PowerVault MD Storage Arrays
• Dell Network Switches:
– S-Series Switches
– M-Series Switches
– Z-Series Switches
– C-Series Switches
5