Setup Guide

Installing Dell OpenManage Connection for

Netcool/OMNIbus

To install Dell OpenManage Connection for Netcool/OMNIbus, you must extract the component-specic les on the systems where you

have installed the Netcool/OMNIbus components and deploy them. For more information on extracting component-specic les, see

Integration Details for Netcool/OMNIbus Components.

Before you begin deploying the les:

1 Download the Dell_OpenManage_Connection_for_OMNIbus_v3_0.zip le from dell.com/support and extract the contents to a folder.

For more information on contents of the zip le, see Dell OpenManage Connection for Netcool/OMNIbus package Details.

2 Log in as Netcool administrator on any system where you have installed any of the Netcool/OMNIbus components.

Topics:

• Dell OpenManage Connection for Netcool/OMNIbus package details

• Installing Probe Integration

• Installing ObjectServer Integration

• The Dell CongUtility

• Installing Desktop Integration

• Installing Web GUI Integration

Dell OpenManage Connection for Netcool/OMNIbus

package details

The Dell OpenManage Connection for Netcool/OMNIbus is packaged as a zip le. This is applicable to systems running Windows and Linux

including VMware ESXi environments. When you extract the Dell_OpenManage_Connection_for_OMNIbus_v3_0.zip zip le, the following

folders and les are extracted:

• desktop_integration

• objectserver_integration

• probe_integration

• webgui_integration

• Dell_OMC_3_0_For_IBM_OMNIbus_IG.pdf

• Dell_OMC_3_0_For_Omnibus_ReadMe.txt

• license_en.txt

NOTE

: Once the folders and les have been extracted, and the system requirements are met with, ensure that you see the

Dell_OMC_3_0_For_Omnibus_ReadMe.txt and the license_en.txt les before you proceed with the installation.

Deploy the contents of the folders on the corresponding Netcool/OMNIbus components to monitor the supported Dell devices.

12 Installing Dell OpenManage Connection for Netcool/OMNIbus