Users Guide

16 Installing the Connection
Installing the Connection on a Managed System
1 Stop the TEC Event Adapter service using the Services Control Panel on the system to be monitored.
2 Copy dellomam.fmt from the Dell Array Manager folder (this folder will be located in the directory to
which you downloaded and extracted the contents of
TEC35A xx .exe ) to the directory where the TEC
Event Adapter configuration file is installed (such as
\tecwin\etc\c ).
NOTE: Back up the tecad_win.fmt file before performing the following step.
3 Append dellomam.fmt to tecad_win.fmt by entering the following command:
copy /b tecad_win.fmt+dellomam.fmt tecad_win.fmt
NOTE: Ensure that no end-of-file character (little square) exists between the appended file or at the end of
the combined tecad_win.fmt.
4 Generate a new .cds file by performing the following steps:
a Make the TEC Event Adapter \bin directory (usually \tecwin\bin ) the current directory.
b Enter the following command from the current directory (the TEC Event Adapter \bin directory):
win_gencds ..\etc\c\tecad_win.fmt ..\etc\tecad_win.cds
5
Start the TEC Event Adapter service using the Services Control Panel.
NOTE: Take a backup of the tecad_win.fmt before installing the Connection. To uninstall the Connection, revert to
the original tecad_win.fmt. Then, generate the new .cds file by typing the following command from the Event
Adapter \bin directory:
win_gencds ..\etc\c\tecad_win.fmt ..\etc\tecad_win.cds