Users Guide

12 Installing the Connection
10 Select both Copy Rules and Copy Classes .
11 Click Copy & Close .
12 Right-click the rule base you created and select Import .
13 Select the option to import class definitions and type the path for dellomsa3.baroc and select the file.
NOTE: If you are using Server Administrator version 1.7 and below, use the path for dellomsa2.baroc.
14 Select Insert After and highlight the last item in the dialog box.
NOTE: You may have to scroll down to view the last item
15 Click Import & Close to exit.
16 Right-click the rule base you created and select Compile .
17 When the compilation is complete, click Close to exit.
18 Right-click the rule base you created and click Load .
19 Select Load, but activate only when server restarts .
20 Restart the event server.
NOTE: To uninstall the Connection, delete all Server Administrator rule bases. Ensure that the rule bases are not
active at the time of deletion. Restore the rule base you used before the Connection was installed.
Installing the Connection on a Managed System
1 Stop the Tivoli Enterprise Console Event Adapter service using the Services Control Panel.
2 If you are using Server Administrator version 1.8 and above, copy the dellomsa3.fmt present in the
Dell Server Administrator (this folder will be located in the directory to which you downloaded and
extracted the contents of the
TEC35A xx .exe ) to the directory where the TEC Event Adapter
configuration file is installed (usually
\tecwin\etc\c ).
NOTE: If you are using Server Administrator version 1.7 and below, copy the dellomsa2.fmt file present in the
Dell Server Administrator folder (this folder will be located in the directory to which you downloaded and
extracted the contents of the TEC35Axx.exe file) to the directory where the TEC Event Adapter configuration
file is installed (such as \tecwin\etc\c).
NOTE: Back up tecad_win.fmt before performing the following steps.
3 Append the dellomsa3.fmt file to the tecad_win.fmt file using this command:
copy /b tecad_win.fmt+dellomsa3.fmt tecad_win.fmt
NOTE: If you are using Server Administrator version 1.7 and below, append the dellomsa2.fmt file to the
tecad_win.fmt using this command:
copy /b tecad_win.fmt+dellomsa2.fmt tecad_win.fmt
NOTE: Ensure that no end-of-file character (little square) exists between the appended file or at the end of
the combined tecad_win.fmt file.