Owner's Manual

Installing and Uninstalling the OpenManage Connection 17

If you have installed the WV component, the

Select MDB

screen is

displayed.

Select the repository in which the DSM classes and objects have been

installed from the

Select MDB

drop-down list. The installer removes the

DSM classes and objects and deletes all data from the repository. If you

want to remove the WV classes and objects, select the

Remove WV classes

and objects

check box.

If you are uninstalling the DSM component, an information message

prompts you to run the

resetdsm

and

awservices start

commands.

Click

Finish

to complete the uninstallation process.

NOTE: If you uninstalled the DSM component and did not select Yes, I want to run

"resetdsm" and "awservices start" now check box, open command prompt and run

the commands;

resetdsm and awservices start.

NOTE: If you have created a localization folder in non-English operating system (in

Management Station) as mentioned in

Post-Installation Tasks

then, you have to

manually remove the localization folder created after uninstalling the EM

component.

Modify

The Modify option in the OpenManage Connection for CA NSM installer

modifies the components that are installed. If you want to install a specific

component, select that component and click Modify. If you want to uninstall

a specific component, clear that component and click Modify. Install the

components in the following order only:

DSM

Uninstall the components in the following order only:

DSM

A5_bk0.book Page 17 Tuesday, December 20, 2011 3:45 PM