Owner's Manual

Installing and Uninstalling the OpenManage Connection 15
Installing the OpenManage Connection in a
Distributed Environment
To install the OpenManage Connection in a distributed environment,
perform the following steps:
1
Install the WV component on a system where the WorldView or Remote
Administrative Client is installed. When you install the WV component,
the OpenManage Connection creates Dell device classes and copies the
icons and images to the respective locations.
2 Install the DSM component on a system where the CA NSM DSM
component is installed. When you install the DSM component, the
OpenManage Connection creates Dell agent classes and menus.
3 Install the EM component on a system where the Enterpise Management
component of CA NSM is installed. When you install the EM component,
the OpenManage Connection creates the Message Record Actions
(MRAs) and action for Dell DRAC SNMP traps.
Upgrading From OpenManage Connection
Version 3.3
You can upgrade OpenManage Connection version 3.3 to OpenManage
Connection version 3.4. To upgrade to the current version:
1
Go to the Dell Support site ( support.dell.com ).
2 Download and extract the Dell OpenManage Connection for CA NSM
installation software.
3 Close all application windows before installing the OpenManage
Connection.
NOTE: Make sure that MDB and all the CA NSM (awservices) are running
fine, and the connectivity exists between different components.
4 Run the installer from the directory that you specified for downloading
and extracting the installation software.
The
Dell OpenManage Connection for CA NSM - InstallShield Wizard
is displayed.
A5_bk0.book Page 15 Tuesday, December 20, 2011 3:45 PM