Owner's Manual

Installing and Uninstalling the OpenManage Connection11
3
Installing and Uninstalling the
OpenManage Connection
This chapter describes how to install, upgrade, and uninstall the
OpenManage Connection.
Installing the OpenManage Connection
To install the OpenManage Connection 3.4 on CA NSM r11.2 SP1, CA NSM
r11.1 SP2, CA NSMr11.2 SP2, or CA NSM r11.2 CUM1, perform the
following steps:
1
Go to the Dell Support site ( support.dell.com ).
2 Download and extract the Dell OpenManage Connection for CA NSM
installation software.
3 Close all application windows before installing the OpenManage
Connection.
NOTE: Make sure that MDB and all the CA NSM (awservices) are running
fine and the connectivity exists between different components.
4 Run the installer from the directory that you specified for downloading
and extracting the installation software.
The
Dell OpenManage Connection for CA NSM wizard is displayed.
5 Read the Dell Software License Agreement and click I accept the terms of
the license agreement.
6 Click Next to continue.
The
Select Features screen is displayed.
7 Select the components that you want to install and click Next .
When you select a component, a short description about that component
is displayed.
A5_bk0.book Page 11 Tuesday, December 20, 2011 3:45 PM