Owner's Manual
40 Troubleshooting and Frequently Asked Questions
SNMP Traps Displayed in Event Console in Raw Format
SNMP traps will be displayed in Event Console in raw format also if they are
processed by a DSM policy. This duplicate display should be prevented by
configuring the Event Management trap daemon. Note the syntax differs
depending on the NSM version.
NSM r11.1 SP2
File: <WVEM>\caiuser\catrapd.cfg
# ignore Dell agent traps
*:*:*:*:1.3.6.1.4.1.674.10892.* ignore
*:*:*:*:1.3.6.1.4.1.674.10893.* ignore
NSM r11.2 CUM1
File: <WVEM>\caiuser\catrapd_ipv6.cfg
# ignore Dell agent traps
*;*;*;*;1.3.6.1.4.1.674.10892.* ignore
*;*;*;*;1.3.6.1.4.1.674.10893.* ignore
Add begin/end markers in order to simplify the uninstall procedure. Changes
in this file become active after a restart of the CA-Unicenter service.
Alternatively, you can restart the trap daemon explicitly using the following
commands:
catrapd sh (shutdown the daemon)
catrapd st (start the daemon)
SNMP Traps from DRAC Devices Not Translated on EM Console After
Installing Connection EM Component
1
Verify that SNMP trap processing is turned on at the management console
so you can receive SNMP Traps.
2
To turn on SNMP trap processing, select
Enterprise Management
→
Configuration
→
Settings
→
SNMP Trap Server Activated
, and set the
value to
ON
.
3
Issue the
opreload
command in the Event Console after installing
DRAC message records(EM component) to load the new records into
the database.