Owner's Manual

22 Installing and Uninstalling the Connection
Uninstalling the Connection
NOTE: Dell recommends that you exit CA NSM before uninstalling the Connection.
To uninstall the Connection from a management station, perform the
following steps:
1
Click the Start button and select Programs → Settings → Control Panel →
Add or Remove Programs
.
2 In the Add or Remove Programs dialog box, select Dell OpenManage for
CA NSM
and click Remove .
The
Uninstall Dell OpenManage Connection window appears.
The uninstallation procedure deletes the Connection and the associated
components that were installed with the Connection.
If you want to uninstall a specific component, select that component and
click
Modify .
If you want to restore or overwrite your installation, click
Repair .
3 If you have installed the WV component, the Select MDB screen appears.
Select the repository in which the DSM classes and objects have been
installed from the
Select MDB drop-down list. The Connection removes
the DSM classes and objects and deletes all data from the repository. If you
want to remove the WV classes and objects, select the
Remove WV classes
and objects
check box.
If you are uninstalling the DSM component, an information message
prompts you to run the
resetdsm and awservices start commands.
When you uninstall the DSM component, the Connection also uninstalls
the
.wvc files (installed when the DSM component is installed).
4 Click Finish to complete the uninstallation process.