Owner's Manual

file:///T|/htdocs/SOFTWARE/smconect/CA_Connections/CA_3.3/en/UG/readme/Readme.txt[10/26/2012 2:47:59 PM]
* T5MK050
NOTE: Please contact CA for getting fixes T115993 and T5MK050
* Close all applications before starting the installation of
Connection
* If you have installed CA NSM r11.1 SP2/r11.2 CUM1 in a distributed
environment, then install the Connection 3.3 only on the system where
the DSM/WorldView/EM components are installed. A message prompts for
you to run the "resetdsm" and "awservices start" commands after the
installation is complete.
* To support proper formatting of PET alerts sent from PowerEdge(TM)
"x9xx" systems with a Baseboard Management Controller (BMC),
modify %AGENTWORKS_DIR%\SERVICES\CONFIG\AWS_SNMP\AWWS_SNMP.CFG as
follows:
* Set aws_snmp to bind to port 162 to listen for traps by setting
the "USE_MGMT_API" property to "No" as follows:
USE_MGMT_API NO
* Add the following line beneath the corresponding BIN_OID
definitions:
BIN_OID 1.3.6.1.4.1.3183.1.1.1
* Make sure that the Windows "SNMP Trap Service" is either not
installed or is disabled. Then stop and restart "awservices" by
running the "awservices stop" command followed by the
"awservices start" command.
######################################################################
KNOWN ISSUES
######################################################################
This section provides information on open issues with this release
of the Connection.
NOTE: This section describes only the latest known issues for the
Connection. See the "Frequently Asked Questions" section of the
"Dell OpenManage Connection Version 3.3 for CA NSM User's Guide"
for additional information about resolving possible issues.
* When uninstalling the Connection for CA NSM, all the necessary
uninstall files are moved from the Dell Program Files folder to the
Windows Temp folder. If user aborts the uninstall wizard for some
reason, the uninstall files remain in the Temp folder. As long as
these files are present in the Temp folder, uninstall of the
Connection will work. However, if the Windows Temp folder is
subsequently deleted, the user may not be able to uninstall the
Connection software. The solution for this problem is to reinstall
the software.