Owner's Manual

file:///T|/htdocs/SOFTWARE/smconect/CAU/cau3.2/readme/readme.txt[10/26/2012 2:50:14 PM]
* If you have installed CA Unicenter version 3.0 or v3.1 in a
distributed environment, then install Connection version 3.2 only on
the system where the DSM component is installed. A message prompts
you to run the "resetdsm" and "awservices" start commands after the
installation is complete.
* To support proper formatting of PET alerts sent from PowerEdge
"x8xx" systems or later with a Baseboard Management Controller (BMC),
modify "%AGENTWORKS_DIR%\SERVICES\CONFIG\AWS_SNMP\AWWS_SNMP.CFG" as
follows:
- Set aws_snmp to bind to port 162 to listen for traps by setting
the "USE_MGMT_API" property to "No" as follows:
USE_MGMT_API NO
- Add the following line beneath the corresponding BIN_OID
definitions:
BIN_OID 1.3.6.1.4.1.3183.1.1.1
- Make sure that the Windows "SNMP Trap Service" is either not
installed or is disabled.
Stop and restart "awservices" by running the "awservices stop"
command followed by the "awservices start" command.
######################################################################
KNOWN ISSUES
######################################################################
This section provides information on open issues with this release
of the Connection.
NOTE: This section describes only the latest known issues for
Connection for CA Unicenter Version 3.2. See the
"Frequently Asked Questions" section of the "Dell OpenManage
Connection for CA Unicenter User's Guide Version 3.2" for
additional information about resolving possible issues.
* The Dell system is present with status as Critical under "Dell
Managed Systems" BPV (Business Process View) after uninstalling
Server Administrator from that system.
(48351)
* The DSM monitoring support for Remote Access Controller (RAC) traps
was added in previous release. The Connection version 3.0 only had
an EM policy to format the RAC traps. To enable use of the DSM
policy, set the trap destination of the RAC to the DSM server.
If your RAC is pointed to both the DSM and EM servers, you will
receive duplicate RAC events. To delete the RAC EM policy: