Reference Guide

Property Description
ScanMode
A FlatPanel's scan mode indicating either single (value=2) or dual
scan (3).
Possible values are:
• 0 = Unknown
• 1 = Other
• 2 = Single Scan
• 3 = Dual Scan
SystemCreationClassName
The CreationClassName of the scoping system.
SystemName
The System Name of the scoping system.
TransitioningToState
Indicates the target state to which the instance is transitioning.
Possible values are:
• 0 = Unknown
• 2 = Enabled
• 3 = Disabled
• 4 = Shut Down
• 5 = No Change - Indicates that no transition is in progress.
• 6 = Offline
• 7 = Test
• 8 = Defer
• 9 = Quiesce
• 10 = Reboot
• 11 = Reset
• 12 = Not Applicable - Indicates the implementation does
not support representing ongoing transitions.
A value other than 5 or 12 identifies the state to which the element
is in the process of transitioning.
VerticalResolution
FlatPanel's vertical resolution in Pixels.
DCIM_IPProtocolEndpoint
Property Description
AddressOrigin
Identifies the method by which the IP Address, Subnet Mask,
and Gateway were assigned to the IPProtocolEndpoint.
Possible values are:
• 0 = Unknown
• 1 = Other
• 2 = Not Applicable
• 3 = Static - Indicates the values were assigned
manually.
• 4 = DHCP - Indicates the values were assigned utilizing
the Dynamic Host Configuration Protocol. See RFC 2131
and related.
• 5 = BOOTP - Indicates the values were assigned
utilizing BOOTP. See RFC 951 and related.
54