Reference Guide

Attribute Name Description
Pen Resume On
Enables or Disables the Resume On Pen setting.
Possible values are:
• Disable
• Enable
Peak Shift
Peak Shift can be used to minimize AC consumption during peak power
times of day. For each weekday listed, set a start and end time to run in
Peak Shift mode. During these times the system will run from the battery
even if the AC is attached as long as the battery stays above the threshold
specified in the Battery threshold field. After the end time specified the
system will run from AC if attached but will not charge the battery. The
system will again function normally using AC and recharging the battery
after the Charge Start time is specified.
Possible values are:
• 1 — Disable
• 2 — Enable
Peak Shift Sun
This attribute configures the power usage configuration for Sunday.
Possible values are:
• 0-23 — Start Hour
• 0-59 — Start Minute
• 0-23 — End Hour
• 0-59 — End Minute
• 0-23 — Charge Start Hour
• 0-59 — Charge Start Min
Attribute names for Set operation:
• Peak Shift Sun StartHour
• Peak Shift Sun StartMin
• Peak Shift Sun EndHour
• Peak Shift Sun EndMin
• Peak Shift Sun ChargeStartHour
• Peak Shift Sun ChargeStartMin
NOTE: To use Peak Shift mode, the values of Peak Shift Start Time,
Peak Shift End Time, Peak Shift Charge Start Time, and Peak Shift
battery threshold are necessary.
NOTE: It is recommended to input values as per the following: Start
Time <= End Time <= Charge Start Time. OMCI can set the out-of-
range values. BIOS behavior is unknown at this point of time for such
values.
NOTE: The values defined for Minute field are 0,15,30 and 45. In case
you set any other value, the value is round to the lower defined value.
Peak Shift Mon
This attribute configures the power usage configuration for Monday.
Possible values are:
• 0-23 — Start Hour
• 0-59 — Start Minute
377