Reference Guide

Dell_RemoteFlashBIOSSettings
Property Description
Caption
The caption of the device.
CompletionCode
This property defines the completion code of the last BIOS update.
Possible values are:
• 1 = Other
• 2 = Unknown
• 3 = Completed successfully
• 4 = Bad Image
• 5 = Could not access flash
• 6 = Flash memory not ready
• 7 = Currently disabled
• 8 = Battery must be installed
• 9 = Fully charged battery must be installed
• 10 = External power adapter must be connected
• 11 = 12 Volts could not be set
• 12 = 12 Volts could not be removed
• 13 = A flash memory failure occurred
• 14 = A general failure occurred
• 15 = A data miscompare error occurred
• 16 = The image could not be found in memory
• 17 = No update operation has been performed
DellInstanceID
This property defines the instance ID of this class.
Description
A short description of the device.
EnableUpdate
This property is used by Dell OpenManage to enable a Remote Flash BIOS update on the
next boot. Dell OpenManage Client Administrator (OMCA) will automatically set this
property to Enabled during remote flash BIOS operations.
Possible values are:
• 1 = Other
• 2 = Unknown
• 3 = Enable
• 4 = Disable
LastBIOSUpdate
This property defines the date of last BIOS update.
SettingID
The identifier by which the Setting object is known.
Support
This property defines whether remote flash BIOS updates are supported by this system.
Possible values are:
• 1 = This system supports remote flash BIOS update
• 2 = This system does not support remote flash BIOS update
322