Reference Guide

Property Description
combined with either OK, Error, or Degraded so that a
client can tell if the complete operation Completed with
OK (passed), Completed with Error (failed), or
Completed with Degraded (the operation finished, but it
did not complete OK or did not report an error).
• 18 = Power Mode - Indicates that the element has
additional power model information contained in the
Associated PowerManagementService association.
• .. = DMTF Reserved
• 0x8000.. = Vendor Reserved
PrimaryStatus
Provides a high level status value, intended to align with Red-
Yellow-Green type representation of status. It should be used
in conjunction with DetailedStatus to provide high level and
detailed health status of the ManagedElement and its
subcomponents.
Possible values are:
• 0 = Unknown - Indicates the implementation is in
general capable of returning this property, but is
unable to do so at this time.
• 1 = OK - Indicates the ManagedElement is functioning
normally.
• 2 = Degraded - Indicates the ManagedElement is
functioning below normal.
• 3 = Error - Indicates the ManagedElement is in an Error
condition.
• .. = DMTF Reserved
• 0x8000.. = Vendor Reserved
•
RequestedState
An integer enumeration that indicates the last requested or
desired state for the element, irrespective of the mechanism
through which it was requested. The actual state of the
element is represented by EnabledState. This property is
provided to compare the last requested and current enabled or
disabled states. Note that when EnabledState is set to 5 ("Not
Applicable"), then this property has no meaning. Refer to the
EnabledState property description for explanations of the
values in the RequestedState enumeration. "Unknown" (0)
indicates the last requested state for the element is unknown.
104