Reference Guide

Property Description
• 10 = Reboot - Refers to doing a "Shut Down" and then moving to
an "Enabled" state.
• 11 = Reset - Indicates that the element is first "Disabled" and then
"Enabled".
• 12 = Not Applicable
• .. = DMTF Reserved
• 32768..65535 = Vendor Reserved
Speed
USB Port Speed in bits per second. This speed is determined and set by
the attached Device. The 'attached Device' is indicated using the
USBConnection association. At this time, only several Port speeds are
valid. These are: 1.5Mbps and 12Mbps. The value 0 can also be specified
to indicate that the current speed is 'unknown' or 1 to indicate that the
speed is 'other' than 1.5 or 12Mbps. Possible values are: 0, 1, 1500000,
12000000
SystemCreationClassName
The CreationClassName of the scoping system.
SystemName
The System Name of the scoping system.
TransitioningToState
Indicates the target state to which the instance is transitioning.
Possible values are:
• 0 = Unknown
• 2 = Enabled
• 3 = Disabled
• 4 = Shut Down
• 5 = No Change - Indicates that no transition is in progress.
• 6 = Offline
• 7 = Test
• 8 = Defer
• 9 = Quiesce
• 10 = Reboot
• 11 = Reset
• 12 = Not Applicable - Indicates the implementation does not
support representing ongoing transitions.
A value other than 5 or 12 identifies the state to which the element is in
the process of transitioning.
DCIM_Memory
Property Description
Access
Access describes whether the media is readable (value=1), writeable (value=2), or
both (value=3). "Unknown" (0) and "Write Once" (4) can also be defined.
Possible values are:
• 0 = Unknown
• 1 = Readable
• 2 = Writeable
• 3 = Read/Write Supported
89