Reference Guide

Property Description
been contacted successfully in the past, but is
currently unreachable.
• 14 = Aborted - Implies an abrupt stop where the
state and configuration of the element may need to
be updated.
• 15 = Dormant - Indicates that the element is inactive
or quiesced.
• 16 = Supporting Entity in Error - Indicates that this
element may be "OK" but that another element, on
which it is dependent, is in error. An example is a
network service or endpoint that cannot function
due to lower-layer networking problems.
• 17 = Completed - Indicates that the element has
completed its operation. This value should be
combined with either OK, Error, or Degraded so that
a client can tell if the complete operation Completed
with OK (passed), Completed with Error (failed), or
Completed with Degraded (the operation finished,
but it did not complete OK or did not report an error).
• 18 = Power Mode - Indicates that the element has
additional power model information contained in the
Associated PowerManagementService association.
• .. = DMTF Reserved
• 0x8000.. = Vendor Reserved
OperationalStatus replaces the Status property on
ManagedSystemElement to provide a consistent approach
to enumerations, to address implementation needs for an
array property, and to provide a migration path from today's
environment to the future. This change was not made earlier
because it required the deprecated qualifier. Due to the
widespread use of the existing Status property in
management applications, it is strongly recommended that
providers or instrumentation provide both the Status and
OperationalStatus properties. Further, the first value of
OperationalStatus should contain the primary status for the
element. When instrumented, Status (because it is single-
valued) should also provide the primary status of the
element.
PhysicalSizeH
Horizontal screen size in cm.
PhysicalSizeV
Vertical screen size in cm.
PrimaryStatus
Provides a high level status value, intended to align with
Red-Yellow-Green type representation of status. It should be
used in conjunction with DetailedStatus to provide high level
and detailed health status of the ManagedElement and its
subcomponents.
PrimaryStatus consists of one of the following values:
• 0 = Unknown - Indicates the implementation is in
general capable of returning this property, but is
unable to do so at this time
• 1 = OK - Indicates the ManagedElement is
functioning normally.
• 2 = Degraded - Indicates the ManagedElement is
functioning below normal.
37