Reference Guide

Property Description
Possible values are:
• 0 = Unknown
• 1 = Not Applicable
• 2 = Is Minimum
• 3 = Is Not Minimum
IsNext
An enumerated integer indicating whether or not the
referenced setting is the next setting to be applied. For
example, the application could take place on a re-
initialization, reset, reconfiguration request. This could be
a permanent setting, or a setting used only one time, as
indicated by the flag. If it is a permanent setting then the
setting is applied every time the managed element
reinitializes, until this flag is manually reset. However, if it
is single use, then the flag is automatically cleared after
the settings are applied. Also note that if this flag is
specified (i.e. set to value other than "Unknown"), then this
takes precedence over any SettingData that may have
been specified as Default. For example: If the managed
element is a computer system, and the value of this flag is
"Is Next", then the setting will be effective next time the
system resets. And, unless this flag is changed, it will
persist for subsequent system resets. However, if this flag
is set to "Is Next For Single Use", then this setting will only
be used once and the flag would be reset after that to "Is
Not Next". So, in the above example, if the system reboots
in a quick succession, the setting will not be used at the
second reboot.
Possible values are:
• 0 = Unknown
• 1 = Is Next
• 2 = Is Not Next
• 3 = Is Next For Single Use
IsPending
An enumerated integer that indicates whether or not the
referenced CIM_SettingData instance represents
outstanding changes to the configuration of the
referenced CIM_ManagedElement that are known to be
pending and are in the process of being applied. A value
of 0 "Unknown" indicates that the referenced instance of
CIM_SettingData may represent the last configuration
applied to the referenced CIM_ManagedElement. A value
of 2 "Is Pending" indicates that the referenced instance of
CIM_SettingData represents outstanding changes to the
configuration of the referenced CIM_ManagedElement
that are known to be pending. A value of 3 "Is Not Pending"
indicates that the referenced instance of CIM_SettingData
does not represent outstanding changes to the
configuration of the referenced CIM_ManagedElement.
Possible values are:
• 0 = Unknown
• 2 = Is Pending
• 3 = Is Not Pending
268