Reference Guide

Property Description
SystemName
The System Name of the scoping system.
TransitioningToStat
e
Indicates the target state to which the instance is transitioning.
Possible values are:
• 0 = Unknown
• 2 = Enabled
• 3 = Disabled
• 4 = Shut Down
• 5 = No Change - Indicates that no transition is in progress.
• 6 = Offline
• 7 = Test
• 8 = Defer
• 9 = Quiesce
• 10 = Reboot
• 11 = Reset
• 12 = Not Applicable - Indicates the implementation does not support representing
ongoing transitions.
A value other than 5 or 12 identifies the state to which the element is in the process of
transitioning.
DCIM_Button
Property Description
ButtonPurpose
The ButtonPurpose property identifies or defines the use of the button
represented by the instance. If the type is set to "Other", then the
OtherButtonPurpose property can be used to further identify the purpose.
Descriptions of the different Button purposes are as follows: A Power
Button changes the power state of a device. A reset button is used to
reset the state of a device. Undock is used to undock or disconnect a
device or entire system from a separate device or system. An Open/Close
button is used on a device that has an object that usually moves such as a
drawer, door, or tray.
Possible values are:
• 0 = Unknown
• 1 = Other
• 2 = Power
• 3 = Reset
• 4 = Undock
• 5 = Open/Close
• 6..32767 = DMTF Reserved
• 32768..65535 = Vendor Reserved
ButtonType
The ButtonType property identifies or defines the type the button
represented by the instance.
Possible values are:
• 0 = Unknown
• 1 = Other
151