Reference Guide

DCIM_NumericSensor
Property Description
BaseUnits
The base unit of the values returned by this Sensor. All
the values returned by this Sensor are represented in the
units obtained by (BaseUnits * 10 raised to the power of
the UnitModifier). For example, if BaseUnits is Volts and
the UnitModifier is -6, then the units of the values
returned are MicroVolts. However, if the RateUnits
property is set to a value other than "None", then the units
are further qualified as rate units. In the above example, if
RateUnits is set to "Per Second", then the values returned
by the Sensor are in MicroVolts/Second. The units apply
to all numeric properties of the Sensor, unless explicitly
overridden by the Units qualifier.
Possible values are:
• 0 = Unknown
• 1 = Other
• 2 = Degrees C
• 3 = Degrees F
• 4 = Degrees K
• 5 = Volts
• 6 = Amps
• 7 = Watts
• 8 = Joules
• 9 = Coulombs
• 10 = VA
• 11 = Nits
• 12 = Lumens
• 13 = Lux
• 14 = Candelas
• 15 = kPa
• 16 = PSI
• 17 = Newtons
• 18 = CFM
• 19 = RPM
• 20 = Hertz
• 21 = Seconds
• 22 = Minutes
• 23 = Hours
• 24 = Days
• 25 = Weeks
• 26 = Mils
• 27 = Inches
• 28 = Feet
• 29 = Cubic Inches
• 30 = Cubic Feet
• 31 = Meters
129