Reference Guide

The Reference Guide contains the
file:///T|/htdocs/SOFTWARE/smcliins/cli81/en/refgd/index.html[10/19/2012 10:01:19 AM]
Processor CMP
Possible values are:
All
1
2
4
6
8
10
12
14
16
Processor Execute Disable
Enables or Disables the No Execute (NX) flag. (NoExecute property in OMCI7.x)
Possible values are:
Disable
Enable
Processor HT Assist
Allow user the ability to disable the Probe Filter chipset option from BIOS setup. There are some applications that may have lower performance with the chipset
feature enabled.
Possible values are:
Disable
Enable
Processor Virtualization Technology
Enables or Disables CPU Virtualization. (CPUVirtualization property in OMCI 7.x)
Possible values are:
Disable
Enable
Processor C State Control
Enable/Disable the C States Control. (CStateControl property in OMCI 7.X)
Possible values are:
Enable
Disable
Processor Core Based Turbo Mode
Enables or Disables Single Core Turbo Mode. (SingleCoreTurboMode property in OMCI7.x)
Possible values are:
Disable
Enable
Processor Logical Processor (HyperThreading)
Enables or Disables hyperthreading on next boot. On some Dell platforms, this property will show Enabled or Disabled despite the platform not supporting
hyperthreading. The platforms in question are those that support Multi-Core processor technology, but do not support hyperthreading. In this case, the property
actually toggles the multi-core capability on and off, rather than hyperthreading.
Possible values are:
Enable
Disable
Primary Battery Charge Configuration
Configures the primary battery charging.
Possible values are:
1 - Standard Charge - Charges the battery over a long period of time
2 - Express Charge - Switches the primary battery to Express Charge mode using the express charging algorithm
3 - AC Use - Recommended setting for users who primarily operate the battery when it is plugged in
4 - Auto Charge - The battery places itself in a mode based on periodic evaluation of customer usage to deliver the best balance of capacity
5 - Custom Charge - The battery starts and stops charging based on the user input
Primary Battery Custom Charge Limit
Charges the battery based on the user input.
Possible values are:
1 - Primary Battery Custom Charge Start Limit - Is applicable to the DCIM_BIOSService for setting the start limit for charging the battery.
2 - Primary Battery Custom Charge Stop Limit - Is applicable to the DCIM_BIOSService for setting the stop limit for charging the battery.
Possible values for the Start and Stop limit are:
Start limit - 50 -95
Stop limit - 55-100
Granularity - Dead band in binary format. For example, if the dead band is 5%, the 'stop charging' value is 5% greater than the 'start charging' value, but is not
allowed exceed 100.
Primary IDE Channel, Master Device
Enables or Disables primary Parallel ATA master channel.
Possible values are:
Off
Auto
Primary IDE Channel, Slave Device
Enables or Disables primary Parallel ATA slave channel.
Possible values are:
Off
Auto
Prompt On Error
Enable/Disable the Prompt on Error.
Possible values are:
Disable
Enable
Rear Single USB
This feature will allow the users to electrically enable or disable the Rear Single USB ports. If disabled, they are unusable in any OS.
Possible values are:
Off
On
Rear Dual USB 2nd stack
Enable/Disable the Rear Dual USB 2nd stack.
Possible values are:
Disable
Enable
This feature will allow the users to electrically enable or disable the Rear Quad USB ports. If disabled, they are unusable in any OS.