Reference Guide

Dell OpenManage Client Instrumentation Reference Guide
file:///T|/htdocs/SOFTWARE/smcliins/cli78/en/refgd/index.htm[10/19/2012 10:04:25 AM]
Description A short description of the video controller.
DeviceID An address or other identifying information to uniquely name the logical device.
DriverDate The DriverDate property indicates the last modification date and time of the currently-installed video driver.
DriverVersion The DriverVersion property indicates the version number of the video driver.
InstalledDisplayDrivers The InstalledDisplayDrivers property indicates the name of the installed display device driver.
MaxMemorySupported Maximum amount of memory supported in bytes.
MaxRefreshRate Maximum refresh rate of the Video Controller in Hertz.
MinRefreshRate Minimum refresh rate of the Video Controller in Hertz.
Name The Name property defines the label by which the object is known. When subclassed, the Name property can be overridden to be a Key property.
SystemCreationClassName The scoping System's Creation class name.
SystemName The scoping System's Name.
VideoArchitecture The video architecture.
The following values are defined:
1 = Other
2 = Unknown
3 = CGA
4 = EGA
5 = VGA
6 = SVGA
7 = MDA
8 = HGC
9 = MCGA
10 = 8514A
11 = XGA
12 = Linear Frame Buffer
160 = PC-98
VideoMemoryType An integer enumeration indicating the type of video memory.
The following values are defined:
1 = Other
2 = Unknown
3 = VRAM
4 = DRAM
5 = SRAM
6 = WRAM
7 = EDO RAM
8 = Burst Synchronous DRAM
9 = Pipelined Burst SRAM
10 = CDRAM
11 = 3DRAM
12 = SDRAM
13 = SGRAM
VideoMode Current video mode.
VideoModeDescription The VideoModeDescription property indicates the current resolution, color, and scan mode settings of the video controller.
SENSORS
This section provides information about sensors. Table 1-5 lists Dell OMCI Sensors classes and properties.
Table 1-5: Dell OpenManage Client Instrumentation Sensors Classes and Properties
Dell_CurrentSensor
Accuracy Indicates the accuracy of the Sensor for the measured property. Its value is recorded as plus/minus hundredths of a percent. Accuracy, along with Resolution and Tolerance, is used to calculate the actual
value of the measured physical property. Accuracy may vary depending on whether the Device is linear over its dynamic range.
BaseUnits The base unit of the values returned by this Sensor.
The following values are defined:
0 = Unknown
1 = Other
2 = Degrees C
3 = Degrees F
4 = Degrees K
5 = Volts
6 = Amps
7 = Watts
8 = Joules
9 = Coulombs
10 = VA
11 = Nits
12 = Lumens
13 = Lux
14 = Candelas
15 = kPa
16 = PSI
17 = Newtons
18 = CFM
19 = RPM
20 = Hertz
21 = Seconds