Manualshelf

Users Guide

ManualsBrandsDell ManualsAnalyticsOpenManage Client Configuration Toolkit 2.2
11121314151617181920
To configure the peak shift battery charging:
1. On the CREATE page, click the required option (Multi-platform File, This System's File, and Saved File).
NOTE: For a Saved File, navigate to the file location and open it.
2. Click Next.
The Create Configuration screen is displayed.
3. On the Create Configuration screen, click Edit or double-click the table.
4. Click View/Change in the Value to set column of peakshiftcfg.
The Peak Shift Charge Configuration dialog box is displayed.
5. Click Edit.
6. Select the Enable PeakShift Charge Config checkbox.
NOTE: If Peak Shift is enabled in the BIOS Setup screen, the Enable PeakShift Charge Config checkbox
appears as checked.
7. In the Start column, select the start time of the Peak Shift period.
NOTE: For Start, End, and ChargeStart, the value of hour must be in the range 0–23 and minute must be 0,15,
30, or 45.
8. In the End column, select the end time of the Peak Shift period.
9. In the ChargeStart column, select the time at which the system has to start functioning by using the AC power and
recharging the battery.
10. Click Save.
Advanced System Management Feature
Advanced System Management (ASM) is a feature supported on Dell Precision R7610 and later workstations. The
feature allows to display the information regarding voltage, temperature, current, cooling device, and power supply
probes. The feature also allows to set the non-critical upper and lower threshold values of voltage, current, and
temperature probes.
Setting The Non-Critical Threshold Values
NOTE: You can set the non-critical threshold values only for voltage, current, and temperature probes.
To set the non-critical threshold values for the probes:
1. On the CREATE page, click the required option (Multi-platform File, or This System's File) and then click Next.
The Create Configuration screen is displayed.
2. On the Create Configuration screen, click Edit or double-click the table.
3. Click View/Change in the Value to set column of advsm option.
The Advanced System Management screen is displayed.
14