Reference Guide

--lpt

Valid Argument lpt1, lpt2, lpt3

Description Defines the parallel port configuration. lpt1 enables the built-in parallel port of the system

to operate in LPT1 mode, using I/O address 378. lpt2 enables the system’s built-in parallel

port to operate in LPT2 mode, using I/O address 278. lpt3 enables the built-in parallel port

to operate in LPT3 mode, using I/O address 3BC.

Example

C:\>cctk --lpt=lpt1

lpt=lpt1

--lptmode

Valid Argument off, last, on

Description

Set the parallel port to:

• disable — Disables the built-in parallel port of the system.

• at — Enables the built-in parallel port of the system to operate in AT mode

(output-only).

• ps2 — Enables the built-in parallel port of the system to operate in PS/2 mode (bi-

directional).

• ecp — Enables the built-in parallel port of the system to operate in ECP mode, no

DMA channel assigned.

• epp — Enables the built-in parallel port to operate in EPP mode.

• ecpdma1 — Enables the system’s built-in parallel port of the system to operate in

ECP mode DMA channel 1.

• ecpdma3 — Enables the built-in parallel port of the system to operate in ECP

mode DMA channel 3.

Example

C:\>cctk --lptmode=at

lptmode=at

--mediacard

Valid Argument enable, disable

Description Enables or disables the media card.

Example

C:\>cctk --mediacard=enable

mediacard=enable

--mediacardand1394

Valid Argument

enable, disable

Description Enables or disables the media card and 1394 devices.