Reference Guide

For example to set the non-critical threshold values for a voltage probe on a system with setup password, type:

cctk advsm --set=voltage_1:10,100 --valsetuppwd = <setup password>

If the system has a system password and no setup password, while setting the non-critical threshold values specify the

system password and set the non-critical threshold values as follows:

cctk advsm --set=<cctk option name>:<lower non critical threshold value>,<upper

non critical threshold value

> --valsyspwd= <system password>

For example to set the non-critical threshold values for a temperature probe on a system with system password and no

setup password, type:

cctk advsm --set=temperature_1:10,100 --valsetuppwd = <system password>

PCI Reporting

The scan of the PCI bus will use a file to resolve PCI vendor and device codes to vendor information strings. The format

of the PCI output is as follows:

PCI Bus: 2, Device: 4, Function: 0

Vendor: 8086 - Intel Corp.

Device: 1229 - 82557/8/9 [Ethernet Pro 100]

Sub Vendor:8086 - Intel Corp.

Sub Device:1017 - EtherExpress PRO/100+ Dual Port Server Adapter

Slot: 01

Class: 02 - Network

SubClass: 00 - Ethernet

If the file for vendor resolution is not present, the utility will print Unknown next to a vendor name. If the file for

environment variable names is not present, the utility will fail the environment variable operation.

The pci.ids file is located at \Dell\CCTK\x86 (32-bit) and \Dell\CCTK\x86_64 (64-bit) on Windows systems and /opt/dell/

toolkit/bin on Linux systems.

Completion Code

The following table displays the completion code of an update operation performed by BIOS in the recent shutdown or

reboot operation.

Table 5. Completion Codes

Code Description

0000h The update was completed successfully.

0001h The image failed one or more consistency checks.

0002h The BIOS could not access the flash-memory device.

0003h The flash-memory device was not ready when an erase was attempted.

0004h Flash programming is currently disabled on the system, or the voltage is low.

0005h A battery must be installed for the operation to complete.

0006h A fully-charged battery must be present for the operation to complete.

0007h An external power adapter must be connected for the operation to complete.

0008h The 12V required to program the flash-memory could not be set.

0009h The 12V required to program the flash-memory could not be removed.