User's Manual

98 Using the BMC Management Utility
Command Syntax:
ipmitool -I lanplus -H <ipaddress> -U <user> -P
<password> -k <kgkey> delloem lcd set mode
{none}|{modelname}|{ipv4address}|{macaddress}|{sy
stemname}|{servicetag}|{ipv6address}|{ambienttemp
}|{systemwatt}|{userdefined}|<text>{assettag}
NOTE: The kgkey (-k option in lanplus) is a string of 20 ASCII characters.
This feature is enhanced for xx1x systems to support the kgkey in hex. The
option is
–x followed by a 40 character hex value. For the lanplus interface to
work, ensure that this kgkey is the same as what is set on the xx1x system.
Except for the default value, the 40 character hex kgkey should start with a
non–zero value. If you enter a value less than 40 characters or any non-hex
values, an error message displays.
• lcd set lcdquallifier : Allows you to set the unit for the
system Watt and ambient temperature modes.
Command Syntax:
ipmitool -I lanplus -H <ipaddress> -U <user> -P
<password> -k <kgkey> delloem lcd set
lcdquallifier
{watt}|{btuphr}|{celsius}|{fahrenheit}
• lcd set errordisplay : Allows you to set the error display.
Command Syntax:
ipmitool -I lanplus -H <ipaddress> -U <user> -P
<password> -k <kgkey> delloem lcd set errordisplay
{sel}|{simple}
• info : Displays information about the LCD display.
Command Syntax:
ipmitool -I lanplus -H <ipaddress> -U <user> -P
<password> -k <kgkey> delloem lcd info
• lcd set vkvm: To set the vKVM status, Active or Inactive .
Command Syntax: