User's Manual

36 Configuring Your Managed System
Alert Destination 1 This field is read-only when LAN Alert Enabled is set to
off.
Enter the IP address of the first alert destination. Use the
Left or Right arrow keys to navigate to each octet. Use the
numeric keypad to enter each octet.
The following IPv4 rules apply:
• IP addresses cannot be 127.xxx.xxx.xxx , where xxx is
between
0-255 .
• The first octet must be between
1-223 (i.e.
143.xxx.xxx.xxx )
• The last octet must not be
0 or 255
(i.e.
xxx.xxx.xxx.0 or xxx.xxx.xxx.255 )
Host Name String Specifies the managed system hostname used to correlate
Platform Event Traps to the system on which they originate.
Use alpha-numerics, but no symbols (except ’-’) or spaces.
Smart Card Logon Select Enabled to enable Smart Card logon. Enabling Smart
Card logon disables all CLI out-of-band interfaces. Select
Disabled to disable Smart Card logon. All command line out-
of-band interfaces are set to their default state. Select Enabled
with RACADM to enable Smart Card logon along with remote
RACADM. All other CLI out-of-band interfaces are disabled.
NOTE: This option is available only on xx0x and xx1x systems.
IPv6 Settings Specifies the LAN Configuration for IPv6.
NOTE: This option is available in the iDRAC6 Configuration
Utility on xx1x systems. See the Integrated Dell Remote Access
Controller User’s Guide available on the Dell Support website
at support.dell.com/manuals for more information.
Advanced LAN
Parameters
NOTE: This option is available only on systems with a DRAC
installed.
Dedicated NIC Configuration Options
NIC Enables or disables the NIC
Auto-Negotiate Enables or disables Auto-Negotiation of the LAN Speed.
Table 2-1. Remote Access Configuration Utility in
x9xx systems (continued)
Option Description