Owner's Manual

file:///T|/htdocs/SOFTWARE/smbmcmu/BMCMU_4_0/en/readme/readme.txt[10/26/2012 11:24:31 AM]

user to save data and quit gracefully. This could result in data

corruption or data loss.

* Storage controllers from PERC 4 and earlier use <ctrl>+M to enter

configuration during BIOS POST. This is the same ASCII value

normally set by the <enter> key so <ctrl>+M will not react as

expected when in a SOL session during boot. Use <esc><ctrl><M> to

enter PERC 4 setup.

Alternate key strokes are provided as BIOS starts up for a number

of special keys. See the "Dell OpenManage Baseboard Management

Controller Utilities User's Guide" for the complete list.

* If you get the message "already installed" when trying to install

the ipmitool Linux .rpm file, use the --force option.

For example,

rpm -Uvh --force <rpm filename>

#####################################################################

Information in this document is subject to change without notice.

Reproduction of these materials in any manner whatsoever without the

written permission of Dell Inc. is strictly forbidden.

Trademarks used in this text: “Dell”, “OpenManage”, “PowerVault”,

and “PowerEdge” are trademarks of Dell Inc.; “Microsoft”,

“Windows”, and “Windows Server”, are either trademarks

or registered trademarks of Microsoft Corporation in the

United States and/or other countries; “Red Hat” is a

registered trademark of Red Hat, Inc. in the United States

and other countries; "Novell" and "NetWare" are registered

trademarks of Novell, Inc. in the United States and other countries.

Server Administrator uses the OverLIB JavaScript library. This

library can be obtained from "http://www.bosrup.com/web/overlib/."

Other trademarks and trade names may be used in this document to

refer to either the entities claiming the marks and names or their

products. Dell Inc. disclaims any proprietary interest in trademarks

and trade names other than its own.

January 2009