User's Manual

96 Using the BMC Management Utility
Default Subcommand
If a subcommand is not specified, this command functions the same as sel
info.
Options for sensor
• list — Displays the complete list of sensors and thresholds in a wide
table format.
•
get < id > ... [ <id> ] — Displays information for sensors specified
by ID number.
•
thresh < id > < threshold > < setting > — Allows you to set a
particular sensor threshold value. The sensor is specified by name. Valid
thresholds are:
•
unr — Upper Non-Recoverable
•
ucr — Upper Critical
•
unc — Upper Non-Critical
•
lnc — Lower Non-Critical
•
lcr — Lower Critical
•
lnr — Lower Non-Recoverable
Default Subcommand
If a subcommand is not specified, this command acts the same as sensor list.
IPMItool Command for Dynamic Entry on the DNS Server When DRAC is
Not Present
To create a dynamic entry on the DNS server when DRAC is not present, use
the following command:
ipmitool raw 0x18 0x58 0xe4 0x15
NOTE: You must enter a 21-byte hexadecimal number (a 8-byte input for the
PowerEdge 1435SC) for the DHCP name. If the DHCP name is less than 21 bytes (8
bytes for PowerEdge SC1435), pad the end with zeroes.