Users Guide

26 Configuring Your Managed System
Host Name String Specifies the managed system hostname used to correlate Platform
Event Traps to the system on which they originate.
Use alpha-numerics, but no symbols (except ’-’) or spaces.
Advanced LAN Parameters NOTE: This option is available only on systems with a DRAC installed.
Dedicated NIC Configuration Options
NIC
Enables or disables the NIC
Auto-Negotiate Enables or disables Auto-Negotiation of the LAN Speed.
LAN Speed Setting This field is read-only when Auto-Negotiate is set to Enabled.
Set the LAN Speed Setting to 10 or 100 Mbps
LAN Duplex Setting This field is read-only when Auto-Negotiate is set to Enabled.
Sets the LAN communication method to Half or Full Duplex.
DNS Configuration Options
DNS Servers from DHCP
on = IP addresses of the DNS Servers are assigned by the DHCP
off = IP addresses of the DNS Servers are set manually
DNS Server 1 This field is read-only when DNS Servers from DHCP is set to
on.
Enter the IP Address of DNS Server 1
The following IPv4 rules apply:
• IP addresses cannot be 127.xxx.xxx.xxx , where xxx is between 0-255 .
• The first octet must be between
1-223 (i.e. 143.xxx.xxx.xxx )
• The last octet must not be
0 or 255
(i.e.
xxx.xxx.xxx.0 or xxx.xxx.xxx.255 )
DNS Server 2 This field is read-only when DNS Servers from DHCP is set to
on.
Enter the IP Address of DNS Server 2
The following IPv4 rules apply:
• IP addresses cannot be 127.xxx.xxx.xxx , where xxx is between 0-255 .
• The first octet must be between
1-223 (i.e. 143.xxx.xxx.xxx )
• The last octet must not be
0 or 255
(i.e.
xxx.xxx.xxx.0 or xxx.xxx.xxx.255 )
Register RAC Name on = You may enter the Current DNS RAC Name.
Register RAC Name This field is read-only when Register RAC Name is set to off.
Enter the Current DNS RAC Name using 1-32 alpha-numerics,
spaces, and symbols. Press <Enter> to save the value. Press <Esc>
to exit the field without saving.
Table 2-1. Remote Access Configuration Utility (continued)
Option Description