Reference Guide

Version Description
8.3.19.0 Introduced on the S4820T.
8.3.11.1 Introduced on the Z9000.
8.3.7.0 Introduced on the S4810.
7.8.1.0 Added support for Multi-Process OSPF.
7.6.1.0 Introduced on the S-Series.
7.5.1.0 Introduced on the C-Series.
6.1.1.1 Introduced on the E-Series.
Usage
Information
The following describes the show ip ospf process-id neighbor command shown in the
following example.
Item Description
Neighbor ID Displays the neighbor router ID.
Pri Displays the priority assigned neighbor.
State Displays the OSPF state of the neighbor.
Dead Time Displays the expected time until the system declares the neighbor dead.
Address Displays the IP address of the neighbor.
Interface Displays the interface type slot/port information.
Area Displays the neighbor’s area (process ID).
Example
Dell#show ip ospf 34 neighbor
Neighbor ID Pri State Dead Time Address Interface Area
20.20.20.7 1 FULL/DR 00:00:32 182.10.10.3 Te 0/0 0.0.0.2
192.10.10.2 1 FULL/DR 00:00:37 192.10.10.2 Te 0/1 0.0.0.1
20.20.20.1 1 FULL/DROTHER00:00:36 192.10.10.4 Te 0/1 0.0.0.1
Dell#
show ip ospf routes
Display routes OSPF calculates and stores in OSPF RIB.
Z9500
Syntax
show ip ospf process-id routes
Parameters
process-id Enter the OSPF Process ID to show a specific process. If no Process ID is entered,
command applies only to the first OSPF process.
Defaults none
Command Modes
● EXEC
● EXEC Privilege
Command
History
This guide is platform-specific. For command information about other platforms, refer to the relevant Dell
Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Open Shortest Path First (OSPFv2 and OSPFv3) 995