Reference Guide

multicast group and optionally a source multicast address in dotted decimal format
(A.B.C.D) to limit the information displayed for a specified multicast source. Enter
the keyword count to display the total number of multicast routes with the
spanned IIF.
Command Modes
● EXEC
● EXEC Privilege
Command
History
This guide is platform-specific. For command information about other platforms, refer to the relevant Dell
Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version Description
9.7(0.0) Added support for VRF. Introduced on the S6000-ON.
9.0.2.0 Introduced on the S6000.
9.2.(0.0) Added support for keyword vlt to the Z9000, S4810, and S4820T.
8.4.1.1 Support for the keyword snooping and the optional vlan vlan-id, group-
address, and source-address parameters were added on E-Series ExaScale.
8.3.19.0 Introduced on the S4820T.
8.3.7.0 Introduced on the S4810.
7.6.1.0 Introduced on the S-Series.
7.5.1.0 Introduced on the C-Series.
E-Series legacy
command
Example (Static)
Dell#show ip mroute static
Mroute: 23.23.23.0/24, interface: Lo 2
Protocol: static, distance: 0, route-map: none, last change: 00:00:23
Example
(Snooping)
Dell#show ip mroute snooping
IPv4 Multicast Snooping Table
(*, 224.0.0.0), uptime 17:46:23
Incoming vlan: Vlan 2
Outgoing interface list:
TenGigabitEthernet 4/13
(*, 225.1.2.1), uptime 00:04:16
Incoming vlan: Vlan 2
Outgoing interface list:
TenGigabitEthernet 4/11
TenGigabitEthernet 4/13
(165.87.1.7, 225.1.2.1), uptime 00:03:17
Incoming vlan: Vlan 2
Outgoing interface list:
TenGigabitEthernet 4/11
TenGigabitEthernet 4/13
TenGigabitEthernet 4/20
Example (VLT)
Dell#show ip mroute vlt
IP Multicast Routing Table
Flags: S – Synced
(*, 225.1.1.1), uptime 00:39:33 flags: S
Incoming interface: Vlan 10
Spanned outgoing interface list:
910 Multicast