Reference Guide

Version Description
pre-6.2.1.1 Introduced on the E-Series.
Example
(Unicast)
mac-address-table static 00:01:00:00:00:01 {output Te 1/2 vlan 2}
Example
(Multicast)
mac-address-table static 01:00:5E:01:00:01 {multicast vlan 2 output—range
Te 1/2,Te 1/3}
Related
Commands
show mac-address-table — displays the MAC address table.
mac-address-table station-move refresh-arp
Ensure that address resolution protocol (ARP) refreshes the egress interface when a station move occurs due to a topology
change.
Z9500
Syntax
[no] mac-address-table station-move refresh-arp
Defaults none
Command Modes CONFIGURATION
Command
History
This guide is platform-specific. For command information about other platforms, refer to the relevant Dell
Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version Description
9.2(1.0) Introduced on the Z9500.
8.3.19.0 Introduced on the S4820T.
8.3.11.1 Introduced on the Z9000.
8.3.7.0 Introduced on the S4810.
7.7.1.0 Introduced on the S-Series.
7.6.1.0 Introduced on the C-Series.
7.4.1.0 Introduced on the E-Series.
Usage
Information
For details about using this command, refer to the “NIC Teaming” section of the Layer 2 chapter in the
Dell Networking OS Configuration Guide.
mac learning-limit
Limit the maximum number of MAC addresses (static + dynamic) learned on a selected interface.
Z9500
Syntax
mac learning-limit address_limit [vlan vlan-id] [station-move-violation
[dynamic]] [dynamic [no-station-move| station-move]]
Parameters
address_limit Enter the maximum number of MAC addresses that can be learned on the
interface. The range is from 1 to 1000000.
vlan vlan-id E-Series only: Enter the keyword then the VLAN ID. The range is from 1 to 4094.
Layer 2 857