Reference Guide

Related
Commands
lsp-refresh-interval — sets the link-state packet (LSP) refresh interval.
maximum-paths
Allows you to configure the maximum number of equal cost paths allowed in a routing table.
Z9500
Syntax
maximum-paths number
To return to the default values, use the no maximum-paths command.
Parameters
number Enter a number as the maximum number of parallel paths an IP routing installs in a
routing table. The range is from 1 to 16. The default is 4.
Defaults 4
Command Modes
● ROUTER ISIS (for IPv4)
● CONFIGURATION-ROUTER-ISIS-ADDRESS-FAMILY-IPV6 (for IPv6)
Command
History
This guide is platform-specific. For command information about other platforms, refer to the relevant Dell
Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version Description
9.5(0.1) Introduced on the Z9500.
9.0.2.0 Introduced on the S6000.
8.3.19.0 Introduced on the S4820T.
8.3.12.0 Introduced on the S4810.
8.3.11.1 Introduced on the Z9000.
7.8.1.0 Added support for multi-topology ISIS.
6.3.1.0 Introduced.
metric-style
To generate and accept old-style, new-style, or both styles of type, length, and values (TLV), configure a router.
Z9500
Syntax
metric-style {narrow [transition] | transition | wide [transition]}
[level-1 | level-2]
To return to the default values, use the no metric-style {narrow [transition] |
transition | wide [transition]} [level-1 | level-2] command.
Parameters
narrow Allows you to generate and accept old-style TLVs. The metric range is from 0 to
63.
transition Allows you to generate both old-style and new-style TLVs. The metric range is from
0 to 63.
Intermediate System to Intermediate System (IS-IS) 827