Reference Guide

Version Description
7.9.1.0 Introduced VRF on the E-Series.
7.6.1.0 Introduced on the S-Series.
7.5.1.0 Introduced on the C-Series.
6.1.1.0 Introduced on the E-Series.
Usage
Information
The following describes the show ip route all command in the following example.
Field Description
(undefined) Identifies the type of route:
● C = connected
● S = static
● R = RIP
● B = BGP
● IN = internal BGP
● EX = external BGP
● LO = Locally Originated
● O = OSPF
● IA = OSPF inter area
● N1 = OSPF NSSA external type 1
● N2 = OSPF NSSA external type 2
● E1 = OSPF external type 1
● E2 = OSPF external type 2
● i = IS-IS
● L1 = IS-IS level-1
● L2 = IS-IS level-2
● IA = IS-IS inter-area
● * = candidate default
● > = non-active route
● + = summary routes
Destination Identifies the route’s destination IP address
Gateway Identifies whether the route is directly connected and on which interface the route
is configured.
Dist/Metric Identifies if the route has a specified distance or metric.
Last Change Identifies when the route was last changed or configured.
Example
Dell#show ip route all
Codes:C- connected, S - static, R - RIP
B- BGP, IN - internal BGP, EX - external BGP, LO - Locally
Originated
O- OSPF, IA - OSPF inter area N1 - OSPF NSSA external type 1
N2- OSPF NSSA external type 2, E1 - OSPF external type 1
E2- OSPF external type 2, i - IS-IS, L1 - IS-IS level-1
L2- IS-IS level-2, IA - IS-IS inter area, * - candidate default
>- non-active route + - summary route
Gateway of last resort is not set
Destination Gateway Dist/Metric Last Change
----------- ------- ----------- -----------
R 3.0.0.0/8 via 100.10.10.10, So 2/8 120/1 00:07:12
via 101.10.10.10, So 2/9
100.10.10.0/24 Direct, Te 2/8 0/0 00:08:54
> R 100.10.10.0/24 Direct, Te 2/8 120/0 00:08:54
C 101.10.10.0/24 Direct, Te 2/9 0/0 00:09:15
IPv4 Routing 735