Reference Guide

Version Description
9.2(1.0) Introduced on the Z9500.
8.3.19.0 Introduced on the S4820T.
8.3.7.0 Introduced on the S4810.
8.1.1.0 Introduced on the E-Series ExaScale.
7.9.1.0 Introduced VRF on the E-Series.
7.5.1.0 Introduced on the C-Series.
6.1.1.0 Introduced on the E-Series.
Usage
Information
The following describes the show ip fib command shown in the following example.
Field Description
Destination Lists the destination IP address.
Gateway Displays either the word “direct” and an interface for a directly connected route or the
remote IP address used to forward the traffic.
First-Hop Displays the first hop IP address.
Mac-Addr Displays the MAC address.
Port Displays the egress-port information.
VId Displays the VLAN ID. If no VLAN is assigned, zero (0) is listed.
Index Displays the internal interface number.
EC Displays the number of ECMP paths.
Example
Dell>show ip fib linecard 2
Destination Gateway First-Hop Mac-Addr Port VId Index
EC
--------------------------------------------------------------------------------
3.0.0.0/8 via 100.10.10.10, So 2/8 100.10.10.10 00:01:e8:00:03:ff So 2/8
0 60260 0
3.0.0.0/8 via 101.10.10.10, So 2/9
00.10.10.0/24 Direct, So 2/8 0.0.0.0 00:01:e8:00:03:ff So 2/8 0
11144 0
100.10.10.1/32 via 127.0.0.1 127.0.0.1 00:00:00:00:00:00 CP
0 3276 0
100.10.10.10/32 via 100.10.10.10, So 2/8 100.10.10.10 00:01:e8:00:03:ff So 2/8
0 0 0
101.10.10.0/24 Direct, So 2/9 0.0.0.0 00:00:00:00:00:00 RP2
0 11145 0
101.10.10.1/32 via 127.0.0.1 127.0.0.1 00:00:00:00:00:00 CP
0 3277 0
101.10.10.10/32 via 101.10.10.10, So 2/9 101.10.10.10 00:01:e8:01:62:32 So 2/9
0 1 0
Dell>
Related
Commands
clear ip fib linecard — clears the FIB entries on a specified line card.
728 IPv4 Routing