Reference Guide

ah-
authentication
Enter the keywords ah-authentication then the transform type of operation
to apply to traffic. The transform type represents the encryption or authentication
applied to traffic.
● md5 — Use Message Digest 5 (MD5) authentication.
● sha1 — Use Secure Hash Algorithm 1 (SHA-1) authentication.
● null — Causes an encryption policy configured for the area to not be inherited
on the interface.
esp-
authentication
Enter the keywords esp-authentication then the transform type of operation
to apply to traffic. The transform type represents the encryption or authentication
applied to traffic.
● md5 — Use Message Digest 5 (MD5) authentication.
● sha1 — Use Secure Hash Algorithm 1 (SHA-1) authentication.
● null — Causes an encryption policy configured for the area to not be inherited
on the interface.
esp-encryption Enter the keywords esp-encryption then the transform type of operation to
apply to traffic. The transform type represents the encryption or authentication
applied to traffic.
● 3des — Use 3DES encryption.
● cbc — Use CDC encryption.
● des — Use DES encryption.
● null — Causes an encryption policy configured for the area to not be inherited
on the interface.
Defaults none
Command Modes CONFIGURATION
Command
History
This guide is platform-specific. For command information about other platforms, refer to the relevant Dell
Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version Description
9.2(1.0) Introduced on the Z9500.
9.2(0.0) Introduced on the Z9000, S4810, and S4820T.
Usage
Information
● Both sides of the link must specify the same transform set.
● You can create up to 64 transform sets.
Example
Dell(conf)#int ten 0/4
Dell(conf-if-te-0/4)#ipv6 address 200:1::/64 eui64
Dell(conf)#int ten 0/6
Dell(conf-if-te-0/6)#ipv6 address 801:10::/64 eui64
crypto ipsec policy
Create a crypto policy used by ipsec.
Z9500
Syntax
crypto ipsec policy name seq-num ipsec-manual
To delete a crypto policy entry, use the no crypto ipsec policy name seq-num ipsec-
manual command.
Internet Protocol Security (IPSec) 685