Reference Guide

Version Description
7.6.1.0 Introduced on the S-Series.
7.5.1.0 Introduced on the C-Series.
7.4.1.0 Introduced
Example
Dell#show interfaces dampening
Interface Supp Flaps Penalty Half-Life Reuse Suppress Max-Sup
State
Te 3/2 Up 0 0 20 800 4500 120
Te 3/10 Up 0 0 5 750 2500 20
Dell#
Related
Commands
dampening — configures dampening on an interface.
show interfaces — displays information on a specific physical interface or virtual interface.
show interfaces configured — displays any interface with a non-default configuration.
show interfaces phy
Display auto-negotiation and link partner information.
Z9500
Syntax
show interfaces {tengigabitethernet | fortyGigE} slot/port phy
Parameters
{tengigabitether
net | fortyGigE}
Enter one of the keywords tengigabitethernet or fortyGigE with slot/port
information.
Command Modes
● EXEC
● EXEC Privilege
Command
History
This guide is platform-specific. For command information about other platforms, refer to the relevant Dell
Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version Description
9.2(1.0) Introduced on the Z9500.
8.3.19.0 Introduced on the S4820T.
8.3.11.1 Introduced on the Z9000.
8.3.7.0 Introduced on the S4810.
8.1.1.0 Introduced on the E-Series ExaScale.
7.6.1.0 Introduced on the C-Series and S-Series.
6.5.4.0 Introduced on the E-Series.
Usage
Information
The following describes the show interfaces tengigabitethernet command following example.
Mode Control Indicates if auto negotiation is enabled. If so, indicates the selected speed
and duplex.
Mode Status Displays auto negotiation fault information. When the interface completes auto
negotiation successfully, the autoNegComplete field and the linkstatus field
read “True.”
654 Interfaces